Go Back   oOple.com Forums > Adam Skelding

Conversation Between Adam Skelding and shep
Showing Visitor Messages 1 to 1 of 1
  1. shep
    18-02-2014
    shep
    Hello i was just looking for bait of help if that is ok ? I have a dex410 v3 and have noticed that my wishbones have a very small amount on wobble where the hinge pins goes through. It is only a small amount but you can notice it when holding the wishbone near the diff and pushing it back and forth.

    Is that normal? I have all the spacers installed correctly and everything is tight.

    Also there is a small amount on play in the caster blocks, they can also be wobbled back and forth when i hold the wishbone near the hub end and plus them back and forth. again the correct spacers are installed and everything is tight.

    I guess this is completely normal but though i would check just to put my mind as ease.
    Thanks
    Harry

All times are GMT. The time now is 01:41 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
oOple.com