LRP Flow Works Team Question
 

Alright all

I have an LRP Flow Works Team which I have taken out of my SV2 and put into a B5M and trying to set it up to the transmitter last night, setting up throttle/neutral/brake it flashes red and blue. I've swapped the sensor wire and it still did it so then re-soldered the wires on the motor and it still did it. Anybody got any clue as to what might be causing it?

Cheers

Hi mate, same issue as last Thursday night? Check that your esc is in channel 2 on the receiver and that none of the motor wires are touching each other :thumbsup:

Alright Dan!!

Yep, checked all that :blush: after last weeks debacle!! Hahaha

I'm pretty sure none of the wires are touching, thats what made me re-solder them after the first time. I updated the firmware last night too and added the v3.8 onto it. I'm down the club later so I'll take it with me along with the iron and see if Chris or Ash may know whats up with it :thumbsup:

You there Thursday/the weekend mate?

Neither this week, working late shifts all weekend from tomorrow :thumbdown:
Did the Novak motor run fine with it last week?
That sensor lead I gave you should be fine.

Rubbish!! :thumbdown:

I put the new one in first just to see if it was naffed then put that lead you gave me back in to be on the safe side. :thumbsup: