Speedo not powering receiver
 

Just fitting my new Muchmore Fleta Pro with ZX motor and cant get the receiver (sanwa) to work so that I can setup. Just went back to my original Tekin and fires up straight away. Any ideas?

Wires in the receiver plug are not in the same order for sanwa... see below.

http://www.fatlion.com/sailplanes/servos.html

Ian

Thanks for this - put simply what wires to I need to move on the plug to get it working? It says on link not to simply turn the plug around as it may cause damage

Not sure - not used Sanwa for over 15 years.

However, since you have another speedo thats working, doing them identical to that might be a good start.

The wires on sanwa are the same as everyone else's, and have been for a number of years. So its just a case of checking if you have it connected to the receiver the right way round.

Seems there is an issue with the product as it is still not powering the receiver at all. Not had any response from Muchmore yet, any ideas what else would cause this inside the ESC?

Just to inform anyone following this, there has been an issue with the latest batch of ESC and the manufacturer will be replacing the item, covering all costs for shipping etc. Fair enough. Thanks for your suggestions anyway