stronger nose cone, X-6
 

has anyone got one to sell ? who will be at batley regional next week end ?

Garry.

Comtact Lesro models, they have had the new one in a while I believe!

should have mine fitted for the weekend & I may even have a spare with me ;)

righty hoe !,

shall have to come finda ya.. will be contacting lesro too shortly to order a few.. had a nasty snap at teeside the other week, ripped the full from end of my x-6 :D , snapped the nose cone in 3 pieces lol

The new one is far far far stronger, so don't go crazy - id recommend having 2, 1 for the car and 1 spare, but you are very unlikely to snap the new one.

Infact, please can everyone reading this take note. Id like to know who is the first person to manage to break one on the track, and pictures of the carnage (including what it hit, as thats likely to be broken too ;) ). :D

Chris

Agreed! I'm still running my one from back in early May, that I slammed into a curb side full punched to see if it would break! I don't recommend doing that, but the new pieces are tough customers.

Do the stronger nose cones come with the new kits? or is it an aftermarket hop up

The new nose cones are now included with new kits, it is not a part upgrade, more a part supercede.

Regarding kits shipped over the last few weeks or so, there may have been a couple of kits slipped through the net and have old nose cones in, if this is the case then a simple email to Chazz and a new one will be sent out. Although asof from now, all is fine and this won't happen.

Chris

Cheers chris;)

Is it also worth getting the short camber link mod or is it possible to do it with the std kit and a bit of time?

Ran them @ Batley outdoors a week back but didn't run without to do back to back test so not to sure what the feel is with or without them.

New camber link mods are £12 from Lesro or you could make a pair. I paid as I couldn't spare the time to knock some up.

Is it just a piece of carbon with some extra holes?

I have never seen the mod, if anyone has a pic it would be appreciated;)

Thanks, that helps a lot

these should help you even more :)

1st ones the prototype they tried and the other 2 are on my car

and check this out

No problem Lee,
The camber link brackets are definately worthwhile. They make the car pivot faster and then square up much better on corner exit. Initially Ellis advised they are best on high grip, but I have found them to be a big improvement on low grip aswell as high grip - in my opinion, a must have!

Chris

Lee,

I'm i to presume that you've purchased an x-6?;)

It's a good car, far easier to drive that the B4....

See ya soon

JIm

Placing the order tomorrow, just finding out whats hot and whats not.

BK2 outer cvd axles are hot
Losi shocks with that setup i sent you are hot (oils and pistons and springs)
camber link hangers and alloy motor clamp are hot

Britich summer, not hot!

Oh and moving the wing as far forward on the stock mounts is hot!!!

What does moving the wing forward do?

Thanks for the help;)