oOple.com Forums

oOple.com Forums (http://www.oople.com/forums/index.php)
-   Electrics (http://www.oople.com/forums/forumdisplay.php?f=26)
-   -   Skyrc Toro 160 lost calibration (http://www.oople.com/forums/showthread.php?t=203429)

lastplace 25-06-2019 03:37 PM

Skyrc Toro 160 lost calibration
 
Hi guys has anyone had any experience with there Skyrc esc lossing it's calibration setting each time it's turned off. If I recalibrate it it will run fine, I can turn off the transmitter . Then turn back on and all still works but if I turn off the esc . Then turn back on it just sits there flashing away looking for a signal from the receiver. I did find put that if I try and recalibrate it when the sanwa Exes X transmitter was set with anti lock set to active it would not complete the calibration process.

pugs 26-06-2019 12:59 PM

Has the esc ever been hooked up backwards....even just for a split second? Iv seen this fault happen on ones which have been reversed connected, blows the flash memory in the main control ic….long as the esc is powered it will work fine, soon as you disconnect the power it loses the set points

mattr 26-06-2019 01:42 PM

:blush:

Yeah, that does happen.......


All times are GMT. The time now is 05:25 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
oOple.com