KF2 Lipo post modification
Hello all,
Just going to try and low profile lipo in my KF2 but just wondering if there is a way that I can modify my original posts so that I can run both low profile and normal lipos. Anyone done anything in the way of this and what are the advantages of using lower lipo Any advice please J |
I just used some dense foam like this:
http://site.petitrc.com/setup/schuma...owskiKF2-6.jpg A bigger piece would stay put without sticking it, so you could pull it out to put a full height in. |
*
Thanks Ian
|
You can cut the posts down, theres still enough thread :thumbsup:
|
I've got some you can have on Sunday Jamie.
|
I use the foam method as above.
If I want to run full size LIPOs then you just swap LH and RH and turn them upside down so the foam sticks up, not down :thumbsup: Wingers |
i drilled a 1.5mm hole at the correct height and use bodyclips to secure.
Nathan Ralls |
*
Thanks chaps for all your help - much appreciated
|
All times are GMT. The time now is 06:20 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
oOple.com