Flow setup for 13.5 boosted
 

Hi,

I am after some advice on speedo set up for a 13.5t boosted touring car.
I have a Flow works competition speedo with the std firmware on it and currently run....indoors on carpet. 13.5 Gforce (black) motor on 40 actual Timing

I am having problems with getting rear traction with the car and wondered if its purely a mech set up problem or perhaps the speedo settings and punch settings are way too aggresive?

I am wondering if I should turn down the boost angle? or boost itself?

Any thoughts?

settings are 0/3/0/6/8/10/0

What is your FDR I run Gforce motors but in blinky also with 40deg timing, this looks high for boosted would say 25ish 6.5 -7 FDR and bring your boost/turbo in slowly, for rear traction when I have trouble I tend to only additive the rears reduce steering EPA as much as can get away with reduce rear droop and stand rear shocks up before looking at the front.

85/21 what ever FDR that is 7.29 probably a bit much for indoors! :lol: so 25deg (No 5) boost and 2.5% (No 6) boostangle?

Is it worth me upgrading the firmware yet bearing in mind its only my second week at touring cars after 10 years away.

They are a good tourqy motor so with a high FDR and 40* it will accelerate quickly but reducing them for boosted should settle it down

anyone else got any advice or settings?