Serpent SDX4 wheel hex compatable with DEX410 ?
 

I'm trying to find out if SDX4 wheel hexes will fit DEX410 ... ? Any SDX4 cross-over owners have a DEX410 handy to find out ??

I'm not sure but I think Serpent uses 12mm hexes, not 14mm. The SDX4 may have been DEX410 inspired, but I don't think there are actually any parts that can be swapped out between the two, aside from screws and bearing that is.

Yes, I took the fact that 12mm seems the prevalent size; as well as the lineage from Durango to SDX4. I'm asking for someone with both to check for fit (not just speculate).

http://www.serpent.com/product/500020

It says it on the product page... surely that will be correct information?

Yes they will and there are different widths available too

THANKYOU !!:D
...follow up question: do you know what the stock numbers are for the different offsets ? all I have is 500212 from the pdf. manual which covers front and rear (which doesn't sound right as usually they are different offsets front to rear on most 4wds-unless I'm mistaken ?)
https://www.rcjaz.com/serpent-500212...-90078066.html

Edit: nevermind; they are listed amoungst the other parts on that site....
https://www.rcjaz.com/serpent-401387...-90078285.html
https://www.rcjaz.com/serpent-401553...-90078922.html
https://www.rcjaz.com/serpent-500211...-90078308.html

Where are you situated?

Sydney.... not sure where that site is based; but am aware it's not here - I just used it as a reference.