I'm hoping I have a faulty gopro, not impressed with the quality it's churning out! Took some dusk footage earlier and it's terrible!

James, yep direct from aeroxcraft. Top service.
It now comes from them ready to run off 3s lipo, originally it ran off 7.4v.

Their RMA service is ok. 1 week turnaround. Mine just got sent to Amsterdam with an audio/mic problem, and I got a new one back today.
Second time its been back, first time it got sent to usa, but i think they are setup to RMA them in the Netherlands now.

Did you just buy it? Tried a software update? They will get you to do that first.

ok, gopro is fine. Just me being critical!
Getting some good footage from gopro in combination with hexa/gimbal.

All blinged up now with led's for a bit of dusk flying (for orientation of craft).
Just ordered the start of my FPV kit, 7' monitor, immersionrc 600mw tx and uno 5.8rx.
Dont know wether to go for the dji iosd or the ezosd, like the idea of using the naza gps rather than adding the ezosd kit, keeps it lighter and simpler.

Gone for the 7' monitor to tide me over until the new Fatshark DominatorHD goggles are released.

:thumbsup:

[IMG]http://farm4.staticflickr.com/3740/9...624ca01f_c.jpg
Untitled by psslocksmiths, on Flickr[/IMG]

[IMG]http://farm8.staticflickr.com/7340/9...75b82ba1_c.jpg
Untitled by psslocksmiths, on Flickr[/IMG]

[IMG]http://farm4.staticflickr.com/3815/9...ff385834_c.jpg
Untitled by psslocksmiths, on Flickr[/IMG]

Looks great Mike, can't wait to see it flying.
When are the dominatorHD's out?

been reading the FPVlab forum and they reckon September but prob will be delayed.
Will try and get to rhr next wednesday night to the 'unofficial rhr flying club!' :thumbsup:

Hex looks mint :)

Tempted by the Gimbal myself but i'm not sure if it would be too heavy for the 450 frame..

cant imagine it would be. Alot of folks are sticking gimbals on phantoms!

it weighs 190g plus gopro.

Another build will commence on Thursday!
DJI F450 this time with kk2 to start with. want to see what all the fuss is about.

Will be needing advice with the kk2 board....

At first it seems massively daunting.
But it's actually really easy:thumbsup: