LRP Flow for 2wd offroad carpet
Hi folks,
Which firmware do you guys use for 2wd offroad on carpet? Still v3.8? Also, what is a good base setup for such a scenario? |
I use the 3.8 version with blinky settings. Br2 brakes with no drag brake and dial down on the transmitter. I find any other brake setting and its either too aggressive low rpm and no high rpm or vice a versa.
|
I run v3.8 on 3-2-2-2-0-0-1. Take torque boost to 2 if you need a little more punch
|
Many thanks for the reply guys.
Much appreciated! |
One question...all these settings are always done with brake EPA set to 80% as recommended by the manual right?
|
I've always set my epas to 100% before setting up my esc. Then adjust from there to suit requirements.
|
As Dan rightly says, set everything to 100% then dial down, not before.
|
I use standard esc and dont mess with the settings, just change motors according to what speed I want.
|
I still prefer the V3.3 Offroad Firmware on my LRP Flow, as its noticeably Smoother than the Newer V3.8!
|
Just wondering as im going to use a flow on yz-2, i asume it will come with 5.4fw so are the other firmwares older or just versions of the same release to suit different classes of rc ?
What I mean is should I go on 3.8 if I'm using a 2wd buggy or stick with newer firmware. |
Quote:
|
Thanks for the advice :)
|
I have a speedo with 3.8 installed, usb bridge and a 7.5 x20 if you are interested, the 3.8 software is much better for off road I think.
|
All times are GMT. The time now is 10:28 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
oOple.com