oOple.com Forums
Page 3 of 3 12 3
Show 40 post(s) from this thread on one page

oOple.com Forums (http://www.oople.com/forums/index.php)
-   News (http://www.oople.com/forums/forumdisplay.php?f=44)
-   -   Vega Elite B4.1 - 2nd Gen (http://www.oople.com/forums/showthread.php?t=107994)

MHeadling 11-09-2012 09:27 AM
You could try something like this:

http://www.oople.com/forums/showthread.php?t=100850

tony12795 11-09-2012 11:08 AM
Gaz, I used the standard motor cover, drilled and tap the Vega motor plate for the hole at the back and use a long screw at the front cover hole, which would clamp to the heat sink. I then made a motor plate out of old lexen, which sits against the Vega MP. Was quite fiddly but work for the five mins a ran it.
<O:p
The standard motor plate will not fit behind the slipper plate unlike the Vega RB5 which does fit. Have a look at Lee's car, this is what I did.<O:p</O:p

gazhillAE 11-09-2012 10:18 PM
Quote:
Originally Posted by tony12795 (Post 693254)
Gaz, I used the standard motor cover, drilled and tap the Vega motor plate for the hole at the back and use a long screw at the front cover hole, which would clamp to the heat sink. I then made a motor plate out of old lexen, which sits against the Vega MP. Was quite fiddly but work for the five mins a ran it.
<O:p
The standard motor plate will not fit behind the slipper plate unlike the Vega RB5 which does fit. Have a look at Lee's car, this is what I did.<O:p</O:p
You changing aswell!?!!
I'm trying both cars back to back
What 4wd now then?
Gaz

Martinst 08-12-2020 01:29 PM
Does anyone still have one of these cars ?

Tom3012 08-12-2020 10:39 PM
I still have a Vega! Pretty much just a shelf queen though


All times are GMT. The time now is 09:11 AM.
Page 3 of 3 12 3
Show 40 post(s) from this thread on one page

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
oOple.com