Setup DEX210 for TORCH
I found James Kerr's setup for the 210 at TORCH decided it would be good starting point as I know very little about setup as you will tell from my first question...
He says to use 3 hole piston 1.6 on the front and 4 hole 1.6 on the rear, the kit seems to comes with 8 x 6 hole pistons and 4 that have no holes. I think one of the guys down at the track mentioned drilling your own holes don't think I really want to get involved with that so can anybody recommend where to buy these? They don't seem to sell them on the Durango site and a Google search doesn't seem to bring up much. And what does the 1.6 mean? Cheers guys!! |
hey dean , you'd need to drill them out using a 1.6mm drill bit
..regards shaun :thumbsup: |
I used this setup when I first started a few months back, was very good! MB Models do shock piston sets, I think you'll need the Type B ones.
|
Cheers guy, just invested in a pin vice!!
|
All times are GMT. The time now is 11:11 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
oOple.com