TA03 Diff in a M05
Hi again,
So I ordered my TA03 diff for my M05 and it arrived yesterday. First off I realised The bearings from my 3Racing one wouldn't fit. So I took the F7 part and a bearing and fitted it to my TA03 diff. It went in fine, but after when I turned the car on it's side the diff outputs slipped out (It had the driveshafts in it and all was assembled) They didn't fall out completely, just slipped a few cm from the diff it's self. I also lost all diff action of course. Hope you can help. (also, could it be I put it together incorrectly?) |
It sounds like you need to put something in the outdrive to take out the gap to the driveshaft. Either an o-ring or one of the urethane bushings used in the top of the trf shocks.
|
couple of damper o rings should do the job nicely.... or a little bit of fuel line
|
Thanks so much!
Worked perfectly, and have gained much speed and drive ability from my car. Hopefully a few more on this happy driving!
|
All times are GMT. The time now is 10:21 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
oOple.com