Forum: 1/8 Nitro Off Road / Rallycross
07-04-2012
|
Replies: 4
Views: 935
|
Forum: 1/8 Nitro Off Road / Rallycross
12-01-2012
|
Replies: 6
Views: 1,369
|
Forum: 1/8 Nitro Off Road / Rallycross
11-01-2012
|
Replies: 6
Views: 1,369
Rebuild with the correct smart diff grease oil...
Rebuild with the correct smart diff grease oil wont let them function as intended.
Starting point would be 4x1.5 with 2 coils cut or 2x1.5 with 2 coils cut
They were only intended to go in the...
|
Forum: 1/8 Nitro Off Road / Rallycross
27-11-2011
|
Replies: 3
Views: 807
|
Forum: General Race Chat
03-06-2011
|
Replies: 10
Views: 918
|
Forum: General Race Chat
03-06-2011
|
Replies: 10
Views: 918
it would be cheaper to just get a compressor.
...
it would be cheaper to just get a compressor.
most cylinders are rented at a cost of about £50/yr for a 10ltr cylinder, you could buy the cylinder but then you become responsible for the testing...
|
Forum: 1/8 Nitro Off Road / Rallycross
27-04-2011
|
Replies: 4
Views: 797
|
Forum: 1/8 Nitro Off Road / Rallycross
25-04-2011
|
Replies: 4
Views: 797
Chassis, arms f+r, driveshafts f r & centre, diff...
Chassis, arms f+r, driveshafts f r & centre, diff crown wheel & pinions f+r, shock towers f+r, shocks (rear only as buggy rear become truck front), turnbuckles, fuel tank, body posts, shell, wheel +...
|
Forum: Team Losi Racing
02-04-2011
|
Replies: 679
Views: 144,339
for the HRC you need the toe plates & the...
for the HRC you need the toe plates & the antisquat shim set.
http://www.horizonhobby.com/Products/Default.aspx?ProdID=TLR2045
http://www.horizonhobby.com/Products/Default.aspx?ProdID=TLR2979...
|
Forum: Team Losi Racing
20-03-2011
|
Replies: 625
Views: 241,602
|
Forum: General Race Chat
15-09-2010
|
Replies: 57
Views: 4,863
|
Forum: 1/8 Nitro Off Road / Rallycross
02-05-2010
|
Replies: 2
Views: 2,043
|
Forum: 1/8 Nitro Off Road / Rallycross
25-02-2010
|
Replies: 30
Views: 3,270
|
Forum: Team Durango
18-09-2009
|
Replies: 1,116
Views: 298,715
|
Forum: 1/8 Nitro Off Road / Rallycross
26-08-2009
|
Replies: 4
Views: 2,597
|
Forum: General Race Chat
13-07-2009
|
Replies: 5
Views: 2,322
|
Forum: Team Associated
13-07-2009
|
Replies: 10
Views: 1,453
A rough guide to setting all shaft drive...
A rough guide to setting all shaft drive gearboxes is
keep adding shims until all lateral movement of the diff is eliminated
starting with all shims on long outdrive put diff in gearbox and check...
|
Forum: 1/8 Nitro Off Road / Rallycross
05-06-2009
|
Replies: 2
Views: 1,144
|
Forum: Hot Bodies / HPI
05-03-2009
|
Replies: 41
Views: 11,250
|
Forum: 1/8 Nitro Off Road / Rallycross
06-02-2009
|
Replies: 1
Views: 1,022
nuts & drive hubs are different between...
nuts & drive hubs are different between manufacturers.
The nuts are M10 but some are fine pitch (1.0mm) others are coarse(1.5mm)
The drive hubs off most race buggies can be swopped around...
|
Forum: Schumacher
26-01-2009
|
Replies: 43
Views: 5,007
|
Forum: 1/8 Nitro Off Road / Rallycross
11-01-2009
|
Replies: 3
Views: 1,193
|
Forum: 1/8 Nitro Off Road / Rallycross
08-01-2009
|
Replies: 5
Views: 1,189
tbh i wouldn't use any of the KO range in a...
tbh i wouldn't use any of the KO range in a rallycross car, i know most of the team drivers use either JR or the ace servos.
if it were my money i'd go ace/associated as these are well proven and...
|
Forum: General Car Talk
08-01-2009
|
Replies: 16
Views: 1,556
|
Forum: Schumacher
29-12-2008
|
Replies: 100
Views: 41,771
Sounds correct it just needs a little bit of...
Sounds correct it just needs a little bit of attention with a dremmel.
Dont go too mad just thin the top of the chassis of a fraction until it doesn't catch anymore this is what i did when i had...
|