Go Back   oOple.com Forums > Search Forums

Showing results 1 to 25 of 93
Search took 0.01 seconds.
Search: Posts Made By: Navek668
Forum: Schumacher 3 Days Ago
Replies: 5
Views: 108
Posted By Navek668
eBay L1 chassis skin couple to choose from tkr or...

eBay L1 chassis skin couple to choose from tkr or rdt products, that one seems to be the one from previous post though, or try Kevin Lee at inside line models great service from him and I think he...
Forum: Bury Metro 5 Days Ago
Replies: 28
Views: 439
Posted By Navek668
Kevan Lee 4wd Pt on system

Kevan Lee
4wd
Pt on system
Forum: R/C Graphy! 10-08-2019
Replies: 10
Views: 534
Posted By Navek668
Can highly recommend n-design on here, excellent...

Can highly recommend n-design on here, excellent paint jobs, communication and always done in good time 👍👍
Forum: 1/10th OFF ROAD 02-08-2019
Replies: 34
Views: 1,709
Posted By Navek668
I would have a look at the Schumacher L1 2nd hand...

I would have a look at the Schumacher L1 2nd hand if you can stretch a little, much better out of the box than an upgraded K2 one went on eBay for just over 200 this week absolute bargain for a...
Forum: R/C Graphy! 28-06-2019
Replies: 625
Views: 68,467
Posted By Navek668
Love your designs Neil, always look forward to...

Love your designs Neil, always look forward to receiving your shells when they are finished 👍
Forum: Schumacher 28-06-2019
Replies: 79
Views: 10,840
Posted By Navek668
I havenít tried but would doubt it would fit snug...

I havenít tried but would doubt it would fit snug or would need to be cut higher at rear end as much lower clearance at the rear on the L1, I may be wrong?
Forum: Schumacher 06-06-2019
Replies: 1
Views: 399
Posted By Navek668
Usually just over a 2 year cycle at Schumacher so...

Usually just over a 2 year cycle at Schumacher so I would think a new car next April/May, still a lot of racing to be done before then
Forum: General Race Chat 29-05-2019
Replies: 3
Views: 418
Posted By Navek668
Have you tried Proline Pinpoints z3 compound work...

Have you tried Proline Pinpoints z3 compound work a treat at Bury on Astro wet or dry and after the Astro was jetwashed some sand came through they still worked great, trim fronts to suit usually a...
Forum: Schumacher 19-05-2019
Replies: 169
Views: 10,598
Posted By Navek668
I just got a craft knife into the recesses at the...

I just got a craft knife into the recesses at the bulkhead where the arms fit in, just a little scrape and everything moved freely
Forum: Schumacher 15-01-2019
Replies: 3
Views: 420
Posted By Navek668
Due to the slim chassis Iíve not seen anything...

Due to the slim chassis Iíve not seen anything else that would fit all other cat bodies are wider as are most of the other 1/10th wheelers
Forum: Electrics 02-11-2018
Replies: 4
Views: 481
Posted By Navek668
Etronix pulse stick transmitter is the same as...

Etronix pulse stick transmitter is the same as the core rc one, although the Gemini will have faster response time, next one up is the Futaba 4grs but then you are looking around 260 new
Forum: Schumacher 29-10-2018
Replies: 11
Views: 658
Posted By Navek668
Iíve broken several front decks at the screws...

Iíve broken several front decks at the screws fitted to front bulkhead, you must be an excellent driver or very lucky!!
Forum: Schumacher 28-10-2018
Replies: 11
Views: 658
Posted By Navek668
Hi, I would keep a set of front and rear...

Hi, I would keep a set of front and rear wishbones, front top decks as they are the weakest point on the car, pivot pins front and rear and the pivot balls and just your normal screws and bearings, I...
Forum: Wanted 25-10-2018
Replies: 9
Views: 292
Posted By Navek668
Have a look on apex models there’s a fastrax one...

Have a look on apex models there’s a fastrax one very similar to the Schumie one they have both on their site but the Schumie is out of stock
Just googled the fastrax one and there are other uk...
Forum: Wanted 25-10-2018
Replies: 9
Views: 292
Posted By Navek668
Not seen a Schumie one but hudy do them wheelspin...

Not seen a Schumie one but hudy do them wheelspin models stock it
Forum: General Car Talk 22-09-2018
Replies: 3
Views: 618
Posted By Navek668
Possible damage to the end of the aerial on the...

Possible damage to the end of the aerial on the receiver, should have about 1/2 inch of white end showing, I have had a similar issue when I used an etronix tx and rx and part of the little white end...
Forum: 1/10th OFF ROAD 02-09-2018
Replies: 3
Views: 445
Posted By Navek668
DMS Racing stock Lunsford turnbuckles, maybe...

DMS Racing stock Lunsford turnbuckles, maybe worth contacting them
Forum: Schumacher 25-08-2018
Replies: 5
Views: 494
Posted By Navek668
Thatís great Peakey, Have you got his email...

Thatís great Peakey, Have you got his email address please
Forum: Schumacher 25-08-2018
Replies: 5
Views: 494
Posted By Navek668
Not had any issues with the captive ball joints...

Not had any issues with the captive ball joints on either K2 or L1 but have had issues with the grippa’s for the steering servo on L1 (no servo saver getting a lot of abuse) and the long grippa’s for...
Forum: Team Associated 03-08-2018
Replies: 1
Views: 421
Posted By Navek668
They are called ball link pliers, donít bother...

They are called ball link pliers, donít bother with the cheap ones they snap very easily, loads on eBay
Forum: Bury Metro 22-06-2018
Replies: 59
Views: 2,559
Posted By Navek668
Cheers Birdy

Cheers Birdy
Forum: Bury Metro 21-06-2018
Replies: 59
Views: 2,559
Posted By Navek668
Hi there, any chance of the results being posted...

Hi there, any chance of the results being posted on here, I donít do Facebook

Cheers

K
Forum: Electrics 07-06-2018
Replies: 11
Views: 672
Posted By Navek668
+1 for the Futaba, receivers £40 quid new for...

+1 for the Futaba, receivers £40 quid new for multiple cars, quick response never looked back after the etronix
Forum: Bury Metro 07-06-2018
Replies: 59
Views: 2,559
Posted By Navek668
Kevan Lee Details on system 4wd Cheers ...

Kevan Lee
Details on system
4wd

Cheers

K
Forum: Wanted 05-06-2018
Replies: 4
WANTED Schumacher k2
Views: 245
Posted By Navek668
Good job!! Did you go for the £99 one has gone...

Good job!! Did you go for the £99 one has gone from eBay now
Showing results 1 to 25 of 93

 
Forum Jump

All times are GMT. The time now is 08:36 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2019, vBulletin Solutions, Inc.
oOple.com