Go Back   oOple.com Forums > Search Forums
Reload this Page Search Results
Register FAQ Community Calendar Today's Posts Search

Page 1 of 2 1 2
Showing results 1 to 25 of 48
Search took 0.01 seconds. Search: Posts Made By: bertberr
Forum: Wanted 21-07-2020
Replies: 0
Views: 621
Posted By bertberr
A few Optima Mid bits required please

I need some bits for an Optima Mid rebuild I'm about to start:

Wheels OT-90, full set. Decent used set, not too badly scuffed.

Front bumper, small.

Thanks
Mike
Forum: Vintage RC 18-07-2020
Replies: 5
Views: 2,198
Posted By bertberr
I didn't, but i was trying to stop the spur from...

I didn't, but i was trying to stop the spur from moving with my index finger as I swung the car up whilst holding the rear wheels. May not have been successful mind, so will put a motor and pinion...
Forum: Vintage RC 17-07-2020
Replies: 5
Views: 2,198
Posted By bertberr
Thanks! I'll be starting the tear down soon, so...

Thanks! I'll be starting the tear down soon, so will certainly have some questions, and based on the fact that both axles seem to turn the same way when turning either L or R wheel, I'm guessing one...
Forum: Vintage RC 17-07-2020
Replies: 5
Views: 2,198
Posted By bertberr
Many vintage Kyosho peeps on here?

Just asking as I've recently bought a well used Optima Mid to restore / refurb, and a). I haven't restored a vintage RC before... and b). I've never owned a Kyosho before... so may have a few...
Forum: Vintage RC 19-06-2020
Replies: 4
Views: 2,100
Posted By bertberr
Any chance of a link to your SW store?

Any chance of a link to your SW store?
Forum: Electrics 01-06-2010
Replies: 11
Views: 1,639
Posted By bertberr
OK, sounds like that's the case then...:mad: not...

OK, sounds like that's the case then...:mad: not had it that long, bought it from a guy on MSUK forum who said it was all working fine... there you are, moral of the story is don't trust any for...
Forum: Electrics 01-06-2010
Replies: 11
Views: 1,639
Posted By bertberr
thanks for the offer, but I really want to know...

thanks for the offer, but I really want to know for sure that this one is buggered before writing it off... :mad:

you say it should show some voltage while charging / discharging, well it does -...
Forum: Electrics 31-05-2010
Replies: 11
Views: 1,639
Posted By bertberr
Hi, any thoughts on what the battery would show...

Hi, any thoughts on what the battery would show in volts after you've completed a half hour or so run with the car and / or the car is starting to slow? If it was a 6 cell 7.2v battery, would you...
Forum: Electrics 11-05-2010
Replies: 11
Views: 1,639
Posted By bertberr
Hi, thanks for checking your charger. Battery is...

Hi, thanks for checking your charger. Battery is for an RC18, taken out of the car mid-way through a bashing session after I managed to break various front end parts including a shock body after a...
Forum: Electrics 10-05-2010
Replies: 11
Views: 1,639
Posted By bertberr
i've got the manual, downloaded from orion...

i've got the manual, downloaded from orion website, but thanks anyway. have to say it's probably the worst manual i've ever read, but having said that the charger is fairly easy to navigate around. ...
Forum: Electrics 10-05-2010
Replies: 11
Views: 1,639
Posted By bertberr
Did your orion advantage always show the relevant...

Did your orion advantage always show the relevant pre-set current on the top line of the LCD display whilst charging or discharging? I'd expect it to show 1.5A there for charging and 1.0A for...
Forum: Electrics 09-05-2010
Replies: 11
Views: 1,639
Posted By bertberr
Orion Advantage Charger

I recently picked up a second hand Orion Advantage Carbon charger, and while I sailed through the set up process OK, I'm having a problem with both the charge and discharge modes.

Anybody with the...
Forum: Electrics 21-04-2010
Replies: 2
Views: 831
Posted By bertberr
anyone got any thoughts on this :confused:

anyone got any thoughts on this :confused:
Forum: Electrics 20-04-2010
Replies: 2
Views: 831
Posted By bertberr
Would these charger lead be OK?

I have an Orion Advantage charger with mini croc's on the output leads, and I need to charge a battery with a deans connector. I was thinking I just buy this -...
Forum: Electrics 19-04-2010
Replies: 14
Views: 1,892
Posted By bertberr
Why is that? Is it just because they're...

Why is that? Is it just because they're smoother, or is it reliability?
Forum: Electrics 15-04-2010
Replies: 3
Views: 918
Posted By bertberr
Thanks for reply, couple of questions though: ...

Thanks for reply, couple of questions though:

What type of connector could have been used with the crocodile clips to start with? There must have been something or Orion wouldn't have supplied...
Forum: Electrics 15-04-2010
Replies: 3
Views: 918
Posted By bertberr
Charger question

Hi, got myself an Orion Advantage Carbon charger that has crocodile clips on the output leads to the battery. Now I'm planning on using deans (female) or 3.5mm bullets (with a male & female each...
Forum: 1/18th & Micro stuff 28-03-2010
Replies: 3
Views: 1,103
Posted By bertberr
Ok haven't heard of Fastrak chassis, will give it...

Ok haven't heard of Fastrak chassis, will give it a few runs then make a decision... only thing that bothers me with the standard plastic one is how flexible it is - holding it in both hands at...
Forum: 1/18th & Micro stuff 28-03-2010
Replies: 3
Views: 1,103
Posted By bertberr
Aluminium Chassis on RC18T

Hi, just wondered what you RC18 boys felt about the ali chassis? There was one on the used RC18T I just bought, though doesn't look as if its been driven yet with the chassis in place as there isn't...
Forum: 1/18th & Micro stuff 28-03-2010
Replies: 13
Views: 3,514
Posted By bertberr
DMS - OK, had a good look at your site, and yes...

DMS - OK, had a good look at your site, and yes you do have all bar one of the items I'm looking for (DP Gear Cover / Dirt Shield), so will be putting together a multiple order over the coming days...
Forum: 1/18th & Micro stuff 26-03-2010
Replies: 13
Views: 3,514
Posted By bertberr
Mark - I'll take another look at the 1/10 wheel...

Mark - I'll take another look at the 1/10 wheel options. A couple of other questions for you...

The truck came from ebay, and included a blue ali chassis which doesn't look like its had any use,...
Forum: 1/18th & Micro stuff 26-03-2010
Replies: 13
Views: 3,514
Posted By bertberr
Oh, fair enough, I didn't realise you did all of...

Oh, fair enough, I didn't realise you did all of that... Of course I'd prefer to get the bits from the UK...

Any thoughts on the difference in diameter if I did get the 1/10 adaptors?
Forum: 1/18th & Micro stuff 26-03-2010
Replies: 13
Views: 3,514
Posted By bertberr
Thanks for the replies. This may be a daft...

Thanks for the replies. This may be a daft question, but I guess the 1/10 wheel/tyre combos are quite a bit bigger diameter than the standard 1/18 ones? I like the look of 58-60mm diameter wheels...
Forum: 1/18th & Micro stuff 26-03-2010
Replies: 13
Views: 3,514
Posted By bertberr
Tyres / wheels for RC18?

Hi, any of you RC18T owners out there got any recommendations for a reasonable value wheel / tyre combo for tarmac use?

Want to save the standard spikes / mini blocks for grass & loose stuff, and...
Forum: Electrics 10-03-2010
Replies: 1
Views: 442
Posted By bertberr
Bump :( Anyone out there know their currents...

Bump :(

Anyone out there know their currents from their currants????

Cheers
BB
Showing results 1 to 25 of 48
Page 1 of 2 1 2

 
Forum Jump

All times are GMT. The time now is 11:18 AM.

Contact Us - oOple.com - Archive - Top

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
oOple.com