[Spoolio]

Originally Posted by SimonBes

For this motor: http://www.teamnovak.com/products/br...8.5/index.html
Which of the supplied pinion gears should I use?
Also, can you just use the velcro to attach the body, or must you use the snap-pins too?!
Thanks!

If you are running a Durga shell I've found that the gaps are just too large to use Velcro as the shell and chassis only touch at a few small points. If you use the supplied foam rubber blocks to bridge the gap and Velcro to that it gives a somewhat flexible fixing and mine always fell off so I've stuck to using the posts and some "big loop" pins off my M03 Mini to make it easier to get them on and off. I think it may be easier to Velcro a Baldre shell as it follows the chassis more closely but I've never actually tried that one yet.