[A.J. Gee]

Originally Posted by SimonBes

For this motor: http://www.teamnovak.com/products/br...8.5/index.html
Which of the supplied pinion gears should I use?
Also, can you just use the velcro to attach the body, or must you use the snap-pins too?!
Thanks!

You can use either one of the supplied pinions 17,23 if I call correctly. The 17 will give you more low end speed (acceleration but a lower top end. and the 23 gives u a higher top end speed, but slower acceleration. You can experiment with a range of pinions. I would go with the 6.5 motor rather than the 8.5, but that's just me. Are you new to the hobby? Also are you on a budget but looking for brushless equipment that's just as good as that Novak. Hit me up if you are. PM style. You can use velcro for the front part of the body (right up until where your suppose to attach the foam pieces on the sides of the body and then just use pins for the back. That's what I did.