Use a starting setup. I would go with 2 hole front, 40wt oil, 1 hole rear with 30 wt oil. Springs i go one or two heavier on the front compared to the rear. Ujs just under level front and rear. Other info you might like is on the vintage car set up page. Setting a standard zxr slipper is a doddle, put car on the deck either on carpet or astro, hold car flat to floor and hit throttle. If it takes off its too tight, if you set it so it sounds like the pads slipping but sounds like its struggling and the cars also trying to pull away then its set.
Last edited by Welshy40; 19-07-2017 at 11:16 AM.
|