Hi spud31,
I'm running the k1 on polished wood, this is my setup at the moment:
Front:
Standard small bore pistons, with 30wt oil and white core rc springs.
Shocks mounted in the middle on the tower and inside on the wishbone. Running 15deg of caster. 1 dink link mount, no spacers underneath. Zero toe and -1.5deg camber. Gear diff with 10k, though tempted to go down to 7.5k
Rear:
Red pistons, 30wt oil, core rc red springs. Middle hole on tower, outside on wishbone. Silver anti roll bar. 3dink mount with 4mm spacers underneath stud, middle hole on hub. Std toe, -1.5deg camber. Wishbone on low roll centre, with 3deg anti squat. Gear diff with 10k oil, though tempted to try 7.5k
Cells in forward position position with alloy chassis.
Toying with running the carbon chassis, but not 100% convinced convincedabout this for polished wood due to the weight loss...?
Hope that helps.
Richard
|