RHR Nathan Ralls setup
front
4 hole pistons
32.5 wt oil losi
3.5lb springs
17.5mm ball cup
no limiters inside
tower middle
wishbone middle
ride height drive shafts just below level
track 1mm with bw brace for strengh
12.5 degree front hubs
10 degree wishbone mount
longest camber link with 0mm washer on inside and 1mm washer outside
10 mm space on steering link
-2.5 degree of camber
0 toe in/out
rear
6 hole pistons
27.5 oil losi
2.5 springs
3/4 lenth turnbukle ball cup with non threads showing
no limiters outside or inside
tower inside wishbone inside
rideheight driveshafts level
wheel base, short
high pin mod used
1mm washer on rear mount (aprox 1 degree of antisquat)
0 on front mount (you will have to dremel the top of the front of the wishbone so it doesnt rub against the purple alloy mount and bind up the suspension)
shocks mounted in kit position the wishbone
3 degrees of toe in
-2 degrees of camber
camberlink longest inside and middle on hub.
aditional info
diffs both in low position
overdrive pulley on front
sx2 s1 chassis used
FAB used set to aprox medium
high speed internal ratios used
6.5 nosram on 23/80
40c 5300 lipos
gm 90
any questions feel free to ask
__________________
Nathan Ralls HPI, Custom Blitz, www.piraterc.com mr-o foams
woop woop racing officialy keeping team toe out inline
|