Thanks for the setup Si but I have a few questions:-
What is the 36T pulley mentioned in the internal ratio section? I only see a 34T pulley being the largest size to get the 2.8 internal ratio.
Do you run the ackerman bar with 8mm between the ball cups as per the manual?
Also the front link bracket you say is 43mm I presume this could be a prototype part as according to the Turnbuckle length guide this is now supplied as U3442 38.5mm rather than 43mm as stated in the manual.
The Worksop report says you ran the 6.5 motor, did you change to the 5.5 for the final?
|