Losi 22 front wheels screws is what I use since my one only wheel dismount, no threadlock. And all good so far with a wheel check before each race
If you have any old 5x4x10mm bearings then get the center from them as a crush tube in the rear hubs, 5mm id 4mm wide, it might help with the drive shafts.
but Schumacher sv2 66.5mm long shafts fit with a little demmel work at the dogbone end.
I added 30g of weight to the car just to get it over the weight limit and sits at 1500grams with either Schumacher or bb's on.
The above and the hinge mod to lose the e clips is all I have done and the car is awesome.
I can't wait to take it around srcc outdoors on the 10th March.
|