[Jayk]

Got a pre assembled sv2 never ran before, only adjusted ride height fitted a 7.5 sp motor, esc had 10% drag nothing else set any different than when it was in a b4, roll bar left on.
All i did was tighten a few lose screws.


My question is why would it do a 360 degree spin when turning with or without throttle either fast or slow ?


After first run i removed drag brake and set the slipper and diff properly, i added longer ball cups to rear shocks as it drooped too much and set the shocks in one hole.
I know its a lot to do without knowing whats causing it but checking what other ppl's setups are like it seems this is common to do this.
Also i think the diff and slipper were wound up a bit tight as niether hardly gave when locking pinion and turning one wheel while holding the other.
This along with the motor having a natural drag effect i think is causing it.

Will be testing it on polished floor soon so hopefully it will run.
Anyone experienced this buggy being impossible to drive like this ??