So... My setup...
Motor Gearing - As standard
Front Ride Height - 4mm
Front Toe In - 0 (Straight)
Ackerman Washers - 1mm
Camber Plate - If I am honest, I don't know how to measure this?? Looking on Chris Ashtons set-up, he says 2º - Is this altered by the little grub screw next to the spring pushing on the chassis?
Front Spring - Green
Centre
Roll Dampers - Oil as standard
O'Rings - Blue
Motor Spacer - 2
Rear Springs - Yellow (Were Blue)
Ride Height Adjuster - Was 4 Dots, just changed to 1 Dot
Diff - Yes
Rear Ride Height - 4mm
30g Weight - Yes
Rear Droop - No idea how to measure?
Rear Droop Screws - No Idea?
Rear Suspension Position - Just changed to outside holes
Ok Chaps... Over to you!!
Best Wishes
Stuart
|