Hmmmmmm I think you might be right about the rear pod width. Most of the parts bar the left hand drive dog are the same, but then you also need to take the eccentric bearing holders into account, which might take a little bit of extra space away, so may make it slight narrower, but it won't be by a huge amount, but probably just enough to make it not work at all. You're spot on about the rear pivot mount too, I really didn't think that one through!
i've also been flicking through the new build manual, and noticed that the front beam is lowered too, by about 2.5mm if you build as per the build insutructions, giving a reduced castor angle, along with no o-ring, I guess to shift the focus onto the droop screws for finer control/set up.
|