Quote:
Originally Posted by HKS_TRD
I could drill the threads and countersink the holes though would a button head screw clear the spur gear? I suspect they would with the LAW-12, will have to look into it when I get back home (out of town at the moment) as it can be dummied up before drilling the threads and the fins are on the motor side not the spur side so a button head screw can seat flat on it
The CF motor plate is very thin, was that for clearance or some other reason?
I have a nylon front gearbox half for this project which has been dyed blue and will be using all titanium screws. Life can get tough on the shelf!
|
If you can drill it and fit a button then hope it all works out.
The cf motor plate was i thought standard thickness, but did base my design on using one of those motor plates in front of the motor (gold like the one you had with your zxs) but tbh it fitted fine for me without it but if you want it thicker you can ask Stephen to do another.
Titanium screws snap easily so if just a shelf then go for it, if a runner stay clear as it will cause you no end of problems.