What is a good setting for the servo saver? My kit instructions says 2mm. I had mine set at 2.2mm. Most of the pro setups just state "tight" It did not feel like it was set too tight. but in 8 months or racing I've gone through 3 composite servo horns. then switched to aluminium and now my 2nd set of gears in my servo. The 16' version kit setup states 3-4mm initial preload and I've compared all the part numbers and every part is the same as my15'. There is no way to get mine to 3mm, it coil binds at 2.5mm.
The car is amazing otherwise. Running indoors on carpet, wood boards for track barriers. I'm easily 1st/2nd place driver at our local club track(when I dont break) barely crash, just bumping the barriers at the most.I've come 2nd place twice with completely stripped gears(the car is a handful to drive lol) Savox sc1257TG servo. which I've used in all my cars without servo savers with no problems at all. I'm going to switch to a heavier servo and maybe set my saver to 1.9mm? Anyone else have any issues? ideas?
thanks Bob
|