[Allan1875]

Pictures as promised.

I had the block machined and then I dremelled away the sharp edge to allow the block move side to side. I also dremelled the block to allow it to go even further back than 2mm.

With the steering arm mod, please note that the titanium turnbuckles are too short and just pull out the ball cup. You will see from the pic for the steering arms I am using kit, although these can be substituted for titanium YZ2 turnbuckles.

Edit: Noticed it's not very clear in the picture of the block fitted. There are 2 x 1mm spacers shown, and at the front there is 1 x 1mm and 1 x 0.8mm spacer. I will be switching the 2 of these to get the 2mm back at the front though.