View Single Post
Old 11-09-2012
gazhillAE gazhillAE is offline
Mad Member
Join Date: Mar 2009
Location: Manchester
Posts: 1,742

Originally Posted by tony12795 View Post
Gaz, I used the standard motor cover, drilled and tap the Vega motor plate for the hole at the back and use a long screw at the front cover hole, which would clamp to the heat sink. I then made a motor plate out of old lexen, which sits against the Vega MP. Was quite fiddly but work for the five mins a ran it.

The standard motor plate will not fit behind the slipper plate unlike the Vega RB5 which does fit. Have a look at Lee's car, this is what I did.
You changing aswell!?!!
I'm trying both cars back to back
What 4wd now then?
Gareth Hill
Schumacher - Sanwa - LRP - Mb models
Reply With Quote