[niggs98]

upper spacers are just a standard 1mm thick washer so 2 of those to raise the ball stud to stiffen it up the roll a little

up position is with the washer below the front hub

2 dgree hubs are an option part (sorry dont know the number)

long wheel base on the hub is to put all the hub spacer washers in front of the hub to push it backwards as far as possible

hope this helps. sorry for the delay in answering your questions but i dont get the chance to look on here very often

Originally Posted by andreasH

Hello all,
I have my Lazer since a couple of weeks. Watching the Lazer category in this forum I found many ideas and good hints.

I just tried setting up my ZX5 like the Batley sheet.
Some general questions for the setup sheets figured out here:
(Maybe because I could not interpret the english name for the parts in the right way)

- Front and rear suspension 'Upper Spacer': Is it an optional part or is it in the kit?
Where to find, which itemnumber?

- Axle Hight Spacer: What is meant by UP or LOW? Is the UP position with the spacer on the bootom?

- Hub Carrier back: How to set up the hub carrier to 2°? Is it an option part or just put the screw to another hole?

- long wheel base on rear hub: What to do here?

Is there an general description for the setup sheet and for the effects using option parts?

Please help me a little here.

thanks
Andreas