Quote:
Originally Posted by Gavin Collingwood
They're kyosho wheels, as far as I know they only fit the rb5/6 possibly tamiya aswell. They are 12mm hex but have a different sized hole and offset to the 22 wheels which are also 12 mm Hex so be careful just coz it's 12 mm hex doesn't necessarily mean they'll fit.
There are two types of cut stagger, the low profile ones like in the pic (which are most common and you have to cut off the excess wheel from the inside to make the wheels narrower. And there's a higher profile cut stagger (less common in yellow compound more common in green compound for wet) which stretches over the full width of the 2.2 front wheel so there's no need to make them narrower.
|
Ah ok cheers for that. Ive sorted the wheels and tires for the rear, its just the front ones im struggling on now, ill have a look into that
do you have a guid to trim the wheel?
Can i ask about you about lipo, esc and motor?
Sorry i am on a massive learning curve with all this at the moment haha
Ive just installed ETRONIX BRUSHLESS MOTOR/ESC COMBO 13T (to start with)
ESC Features;- Input: NiMH 4-8 cells & LiPO 2-3 cells & LiFe 2-3 cells
- Output: Max 360 Watt, 54A at 54°C, 45A at 75°C, Peak 240A
- Motor support: KV < 4500KV, 1:10 scale car
- BEC: 5V / 2A
- Net weight: 72g
- Dimension: 48x33x29mm
Motor Features;- 13.0R 3000KV
- Max Amps: 33
- Resistance: 0.0255
- I0(A): 1.2
- Shaft: 3.17mm
- Weight: 172g
and ive got a 4000mah 2S 25c (50c burst) lipo
which give 100amps (i think)
would these be sufficient for the above setup?
many thanks again
chris
chris