View Single Post
  #157  
Old 18-10-2011
Miggers Miggers is offline
Member
 
Join Date: Aug 2007
Location: South Cheshire/North Staffs borders
Posts: 249
Send a message via Skype™ to Miggers
Default

Good work mate.

It'd probably be easier to take 0.5 from the bearing faces than from the outdrive inner faces,they're rock hard,though if you could have got them in a suitable lathe's chuck you'd have skimmed it off easily.

Not sure about skimming 0.5 from the outdrive bearing seats though,
they'd have probably fractured across the dogbone slots.
It'd be a mare to shim the slots out to support things whilst they were
being machined too.

Do you think you could get a couple of slipper plates turned up for me
at all?
Reply With Quote