View Single Post
  #1  
Old 07-12-2014
coupehdi coupehdi is offline
New Member
 
Join Date: Dec 2012
Posts: 5
Default Setting the tweak

Hi, I normally sett the tweak on my cars by the old way of, simply setting it down ready to race and lifting it dead center in the front, see what wheel lifts first and adjust rear springs as necessary till both lift together, this is always what i did with 10th scale but i think this mardave cars different, cause to get it right i need to tighten down the right rear spring alot more than the left, (like about 4 or 5 turns difference), the chassis is straight and pods all square, nothings bent ive checked it cause it seemed like way too much to me, but the motors fitted to the right hand side of the pod, so is it just because the spring on the side of the motor needs to compressed to support the extra weight placed on that side?

Or is there a better way to set the tweak on these cars?

I'm pretty happy with the handling at the minute but if it could be better that'd be great lol
Reply With Quote