Quote:
Originally Posted by Benh
My tips for it are:-
Open the diff, and shim the outdrives. what shims
Do the same for the bearings too.what shims or do you mean swap out bearings?
There may be easier ways but I'm drilling the ends of the prop shaft, cutting a thread and inserting a grub screw in the ends to lock in the pins. They come loose after a few runs. pics ??
Take off the front hubs and dremel a small amount away. pics ??
Whilst you have the dremel out.
Fashion a couple of bits of plastic that can bolt onto the rear tower that will allow you to drop the inside camber link....pics ??
O rings could with a change... What should it be swapped out with
Hope that helps.
|
Could you get up some pics please