Henceforth known as the TC02T+
I made this new T-Piece at work, a few lunchtimes and a bit on the sly. Made of 6062.
Then, obviously, that's never the end is it, I found I needed to make some parts to partner it, so these lovely little braces took shape. The astute among you may also notice the cell brace, a bit of ali, bandsawed up, filed and bent, painted, then screwed to the original part.
Then, the last piece was to solve the fiddly rear body clip issue, so I moved the rear mounts back a bit to relocate the body pins, thus making it easier. Lowered too, so body sits lower. Had to mod the front ones too for it to sit lower across the board.
The finished result, as you can see, from where the rear posts were to where they are now, it's a whole lot easier
