[lastplace]

Update on HB D413 hex they are sloppy fit the HB has a 5mm shaft the Durango use a 4.75mm shafts it also will need a 1mm spacer to pack the back play out good news the pin is the same ,I'm going to try some insulation tape around the shaft .also not sure about the wheel off sets on none Durango wheels compared to the Durango wheels. Have been looking at Extor ?? Push over clamping hex have found several part numbers that are for the Durango front but they look like they will push the wheels out to far .the car has to fit in the size box to be legal for our regional races. And the Durango has always been a very tight fit.