Quote:
Originally Posted by Aire valley
Nice..👍
What is that rear diff...?
|
It's a dremelled down m05/m06 stock gear diff. I used the internals from a tt01 (outdrives with flats instead of splines), as I stripped my stock ball diff at the splines and wanted something beefier.
You'll need to Dremel off the flanges on both sides of the diff case, and dress the gears (which might get a little distorted after dremelling), to fit the topforce/ta01/ta02 gearbox.
It works great, but it is not sealed, so I only grease it with some light lube.
If you're just building your topforce/mantaray, don't bother using a rear ball diff... It will strip so quickly you can't believe. The front ball diff seems a little less prone to strippage.
Alexander