[lastplace]

OK have now sorted found the missing D4 12mm hex did our own Broxtowe regional last weekend car was tight fit in the box ,the pin sinks into the hex by 0.6 mm this pushed out the shafts by 1.2mm have now reduced the hex face down so the pin is flush with the hex so will now fit , there is a review posted on the Exotex site that says it makes the car wider so suspect same problem with the pin in too deep, one of the guys had a Associated B44 hex part number 9955 ? This is the correct shaft size will also need to be shimmed out but the pin still sinks in too far so the hex would need to be reduced .