Quote:
Originally Posted by OldTimer
Remember you need to add the front camber links, these always seem to get in the way  |
Hehe thanks for the tip! I removed them to reduce the chance of errors in SolidWorks: It seems SolidWorks just can't seem to understand ball joints and concentric mates very well if you have a lot of them. Apparently removing the front links wasn't enough, as it doesn't listen to any of the concentric mates I set anymore: The ball connectors don't stay in their adjusters anymore whilst it did work yesterday. Ah well, time to re-assemble the low - again
Anyway, to come back to your point: I checked yesterday if the upper links would fit. They need to move to the front a bit, but it will fit. It's almost too tight for comfort, but it will have to do
The DEX210's inner rear adjusters may help to create a little more room by the way.