View Single Post
  #36  
Old 28-08-2017
Origineelreclamebord's Avatar
Origineelreclamebord Origineelreclamebord is offline
Mad Member
 
Join Date: Sep 2010
Location: Netherlands
Posts: 1,571
Default

We have looked at parts compatibility for the FF210 and compiled a list with compatible parts and 'must-stock' items to keep your buggy running.

First off, the compatible parts. Please keep in mind we have done our best to check the parts fit from 3D models and, where opportunities arose, on the car. However, these alternatives have not been tried and tested on the track.

Therefore, WE DO NOT GUARANTUEE THE REPLACEMENT PARTS' PERFORMANCE, LONGEVITY OR FIT (WITHOUT MODIFICATION).

Driveshafts: Use a combination of:
- B5M CVA Kit (91440);
- Hexes (91441);
- CVA Wheel/Hex Pins (91436);
- 6x13x4mm Ball bearings. Note the specified ball bearing has a bigger inner diameter than DEX210, but is narrower than the B5M wheel bearing.
- Note the dogbone end of the 91440 driveshaft fits a little tight on the side of the diff screw/thrust bearing of the (ball diff) outdrive. Use a dremel to shave off a little material from the dogbone head or inside the outdrive as needed to make the driveshaft move in and out of the outdrive without friction.

Shocks: Use a combination of:
- Durango shock tower screws (TD708013)
- B5/B6 shock bushings (91445)
- B6 kit shocks (23/27.5mm big bores), OR;
- B5M shocks (23/31mm big bores) with 3mm limiters in the long shocks
- Note the Durango shock nut fits on the Associated shock bodies to make your Durango springs fit neatly.
- Other brands of shocks may fit; keep in mind that the extended length is key to the car's performance because of its droop setting; also check the car can still bottom out to prevent damage when landing jumps.

Suspension pivot balls (front suspension):
- Use TRF/Tamiya 5mm suspension balls (50994) or an aftermarket pivot ball that fits (Exotek, 3Racing & more).

Have you also found non-Durango parts that fit? Please share your findings!

Based on the parts compatibility we found so far, our advice for FF210 customers is to stock at least the following Durango parts:
- Gear Casing (Type B)
- Long ball diff outdrives
- Main Gear
- Idler Gear Set
- RR Hanger (HRC, Type B)
- O-rings (if you keep using Durango shocks)

__________________


3D Printing Upgrade Parts - FF210 Buggy
Reply With Quote