Good evening Lewis, taken a while but finally been authorised after a fair few messages to admin and on Facebook etc.
It is I who Qatamix was asking about.. 😁 I was doing some searching and found he’d messaged here! I thought I’d found someone with the same problem! 😂😂
So after quite a ordeal it appears “touch wood” I resolved the issue fitting a new pot, I’d done a lot of searching trying to figure it out, and kept coming back to these pots.
https://www.mkracing.eu/sanwa-lenkun...53l00064a.html
Found on eBay and a few places on Google, but these guys also had the throttle one available.
When opening the back once arrived the spec didn’t say for exzes x, but it looks identical and had the same ohmage rating, and as it failed a second time, I decided to go for it.
Thought it’d be a quick ish job but it took over an hour in the end, I got the pot out fairly quickly but struggled to clear the solder even with a solder sucker and stuff, so I actually hand drilled through the solder with a 1mm and 1.5mm drill bit.
Once fitted and testing I found the figures had changed when moving from throw to throw, but it worked perfectly, i calibrated and tested last Thursday and worked great for 5 5min races, and again last night, so this is now easily the longest it had made it. So I’m now fairly sure it was the pot,
When removing I did find it had gone notchy, possibly from pulling at it to remove it or it was indeed faulty.
If you make sure to have a decent wattage iron it’s not too bad to do..
Hope this helps!
I’m new on here but if you need pics, let me know and I’ll try and upload them.. 😁