View Single Post
  #42  
Old 11-09-2012
tony12795 tony12795 is offline
Senior Member
 
Join Date: Aug 2006
Posts: 909
Default

Gaz, I used the standard motor cover, drilled and tap the Vega motor plate for the hole at the back and use a long screw at the front cover hole, which would clamp to the heat sink. I then made a motor plate out of old lexen, which sits against the Vega MP. Was quite fiddly but work for the five mins a ran it.

The standard motor plate will not fit behind the slipper plate unlike the Vega RB5 which does fit. Have a look at Lee's car, this is what I did.
__________________
http://insidelineracing.co.uk
Reply With Quote