Hi Tony.
Sounds like you might need to recheck your speedo setup and EPA on your transmitter before splashing out on a new ESC.
Set the transmitter brake EPA/travel to be full/100%.
Set brakes travel on ESC to be 100%.
Reprogram the ESC (power on holding set button until red light flashes).
Leave Tx throttle at neutral and press ESC set button
Full throttle held on Tx and press ESC set button
Full brake held on Tx and press ESC set button (3 bleeps).
Release back to neutral and give full beans then full brakes and it should stop instantly!!
Normally in 2wd I run 75-90% brake EPA on Tx to dial in feel and grip levels.
4wd 90-100%.
Hope this helps!
M
__________________
:: AE B5MCE - SP 7.5 v3.0 Brushless Motor - Reedy Shorty Lipo - Savox Servo - Spektrum Rx ::
:: Paint By Turnip Paint ::
|