B6 Setup - Kidderminster May 2017
Here's my B6 setup from Kidderminster in th dry today.
Front:
37.5 weight oil
2x 1.6 pistons
Orange Spring
Short shock end
Middle hole on gull wing tower
Middle hole on gull wing arm
Plastic arms
Alloy bulkhead
0.5mm shim under chassis/above bulkhead
21mm ride height
5 deg caster
25deg kickup
1mm from bottom axle height
STD Ackerman
1 deg camber
Middle on camber link, 1mm washer inside
Inner on hub for camber link
Rear:
30wt oil
2x 1.7mm piston
Grey spring
21mm ride height
Middle hole on tower
Inner on arm (plastic)
Kit anti squat and toe in
0mm axle height on hubs, (pin at top)
Medium wheelbase
Shocks on front of arm
1.5 deg camber
Middle, 2mm washer under ball stud on inside
Middle on hub, upper position
Others
Steel ESC and Servo weight
Alloy bulkhead
No weight under 4100 full height lipo
HW 3.1 speedo
Full size hi-tec servo
Reedy M2 7.5 motor - 21/78
Sch yellow cut stagger (no foam) narrow wheel
Sch yellow darts, blue medium foam, std wheel.
Anything else just ask.. :-)
__________________
:: AE B5MCE - SP 7.5 v3.0 Brushless Motor - Reedy Shorty Lipo - Savox Servo - Spektrum Rx ::
:: Paint By Turnip Paint ::
|