I plan on installing the standard WCE 10 deg. caster blocks soon and wondered where is everyone putting the ball stud and what height spacer? Per the instructions and some setups I found here, I should put it directly over the CVD (inner most hole over the CVD that is)... shown here too...
http://i25.photobucket.com/albums/c9...o/IMG_5921.jpg
I found some posts by DCM by searching "caster" here in the Tamiya section and he posted this about the spacer height...
http://www.oople.com/forums/showpost...37&postcount=7 Granted, this is for a DB01/Durga but what do you think?