|
#1
|
||||
|
||||
mad rat moter mount, and help with brushless set up
built up my mad rat kit and the screws in the motor mount strip really really easly, any one else had this ? do thay replcae them, is there fault ?
also.. just ballraced it, any any one unsing a brushless set up in theres if so what motr you using, will a 6000kv plus 60amp esc be to much on 2sell lipo ? will the stock pinion be a good starting point ? regards dan |
#2
|
||||
|
||||
Quote:
This is a know fault some madrats were released with a faulty batch of motor plates contact ansmann for a replacement
__________________
|
#3
|
||||
|
||||
just get some 30mm threaded screws (button head, but preferablt small button like a hex fitting). screw them in from teh slipper side into some 3mm lock nuts.
I will post some pics in my build thread on my blog later today
__________________
http://www.thercracer.com/ |
#4
|
||||
|
||||
__________________
http://www.thercracer.com/ |
#5
|
||||
|
||||
i was sent shake proof washers and nuts and bolts from ansmann to fix the problem
__________________
DO NOT BUY/SELL TO THIS USER. |
#6
|
||||
|
||||
nyloc nuts are just a bit easier to use
__________________
http://www.thercracer.com/ |
#7
|
||||
|
||||
yer of corse they are i was just saying what they sent me
__________________
DO NOT BUY/SELL TO THIS USER. |
|
|