|
|
#1
|
||||
|
||||
slipper connecting cup (T02182)
I still get heavy wear on the slipper connecting cup (T02182) anybody know if there is a hardened version of this
TM2v1
__________________
Fray Bentos |
#2
|
||||
|
||||
There is not a hardned version at the moment.
If you clean and grease it after a day racing. It wil last a full season racing Same for al the axels.
__________________
PR racing precirotate s1v2/sb401 |
#3
|
||||
|
||||
Thanks but what grease do you use
__________________
Fray Bentos |
#4
|
||||
|
||||
I use a lithium base grease.
__________________
PR racing precirotate s1v2/sb401 |
#5
|
||||
|
||||
Quote:
Please don't throw the old ones away Lee. I want to investigate. Are you racing on Sunday? |
#6
|
||||
|
||||
No I am not going for a few weeks but will keep them for you
__________________
Fray Bentos |
#7
|
||||
|
||||
Quote:
pm your address and I can send you one Mike |
#8
|
||||
|
||||
Clive how about making one like a MIP puck drive?
|
#10
|
||||
|
||||
Is that like this?
Sadly Mike's drive shaft fell out of the envelope on its way to me so I won't be able to assemble it. The pad/puck will be brass but the material is also in the post somewhere so I proved the programming with some aluminium. I think that with the pad/puck in brass it should be possible to recover even badly worn cups as the pad spans the notch. Last edited by Clive Loynes; 17-09-2014 at 09:52 PM. |
#11
|
||||
|
||||
Looks good Clive. No problem to drive pin out and re-assemble.
Mike Last edited by welshmerlin; 17-09-2014 at 11:37 PM. Reason: .. |
|
|