Driveshaft disengaging on FS2

[/tobys]

Ran FS2 yesterday (until it got too wet) and it was great in practice.

However, I noticed after R1 (which I only 1/2 completed due to shoddy tyre gluing LOL) that the front centre driveshaft had become disengaged from the plastic drive cup.

Looking at it, there is quite a bit of movement possible there and unlike the rear, there is no method for adjustment. To reduce the available movement, I was planning to put a small piece of fuel pipe into the drive cup.

Anyone else had this problem and/or see any issues with my solution?

[njc11]

You should have the little white plastic part in the spur gear side outdrive..

Its the same part you would use in differential outdrive which is found on the parts tree of LA200..

http://www.infernosonly.com/Kyosho_D...p/kyola200.htm

HTH

Nick

[mattb]

I think nearly everyone i know me included missed this and trashed the front gearbox drive cup lol

[Gayo]

+1

[/tobys]

yes, thats my problem!

thanks all

[chatts#725]

Originally Posted by Gayo

+1

+2

[RogerM]

read the instructions ... make a cuppa then read them again