|
|
#1
|
||||
|
||||
B6 Setup - Kidderminster May 2017
Here's my B6 setup from Kidderminster in th dry today.
Front: 37.5 weight oil 2x 1.6 pistons Orange Spring Short shock end Middle hole on gull wing tower Middle hole on gull wing arm Plastic arms Alloy bulkhead 0.5mm shim under chassis/above bulkhead 21mm ride height 5 deg caster 25deg kickup 1mm from bottom axle height STD Ackerman 1 deg camber Middle on camber link, 1mm washer inside Inner on hub for camber link Rear: 30wt oil 2x 1.7mm piston Grey spring 21mm ride height Middle hole on tower Inner on arm (plastic) Kit anti squat and toe in 0mm axle height on hubs, (pin at top) Medium wheelbase Shocks on front of arm 1.5 deg camber Middle, 2mm washer under ball stud on inside Middle on hub, upper position Others Steel ESC and Servo weight Alloy bulkhead No weight under 4100 full height lipo HW 3.1 speedo Full size hi-tec servo Reedy M2 7.5 motor - 21/78 Sch yellow cut stagger (no foam) narrow wheel Sch yellow darts, blue medium foam, std wheel. Anything else just ask.. :-)
__________________
:: AE B5MCE - SP 7.5 v3.0 Brushless Motor - Reedy Shorty Lipo - Savox Servo - Spektrum Rx :: :: Paint By Turnip Paint :: |
#2
|
||||
|
||||
How long were you getting out of the darts Mark ?
__________________
Stevie Brew BW-RACING@HOTMAIL.COM http://www.oople.com/forums/showthre...hlight=stegger |
#3
|
||||
|
||||
Well I had two pairs of rears.
One scrubbed set, one new. Whilst they were visibly worn, I reckon I could use them for another meeting with ease. Minispikes would have one set nearly bald from last year, so a big improvement in my opinion! Without any tarmac, I reckon two meetings easily.
__________________
:: AE B5MCE - SP 7.5 v3.0 Brushless Motor - Reedy Shorty Lipo - Savox Servo - Spektrum Rx :: :: Paint By Turnip Paint :: |
|
|